The living Porsche parts archive.

Replacement plug that covers an enlarged screw hole in the interior pillar trim.

Replacement hose connecting the mass airflow sensor to the airbox.

Custom spacer plate for a door-mounted stereo speaker.

Custom front wheel seal installer.

Replacement (88 later) sunroof cam.

Custom phone holder.

Replacement driver door trim window.

Replacement hvac heating knob.

Replacement window switch panel.

Cupholder-mounted MagSafe phone stand for PDK interiors with the deeper cupholder slot. The creator recommends PLA+ or carbon-fiber PLA and states the design was tested only on the 992.2.

Replacement electric sunroof latch.

Replacement center-console assembly laid out for a double-DIN radio installation.

Four-piece ashtray-insert phone mount for 2010-2016 970.1/970.2 cars, designed around the Asus ROG Phone II. The flexible base and wedge friction-fit in the ashtray while the rigid arm and body bolt together; installation uses no clips, adhesive, or vehicle modifications.

Replacement back cover roller brackets.

Drop-in ashtray replacement with a removable cupholder insert.

Streamlined replacement alternator cooling duct modeled from a 3D scan of the original failure-prone part and shaped for support-free printing. The creator printed it in PA12 and reports that PETG has also been tested.

Replacement windshield-washer reservoir filler neck supplied as a primary neck plus mounting bib, with an alternate split-neck version for smaller printers.

Replacement cap for the Cabriolet hardtop-latch opening. The creator says it hides the latch mechanism, may need approximately 1% scale adjustment depending on printer accuracy, and should be printed flat-side down.